iRig Acoustic Stage
The IK Multimedia iRig Acoustic Stage is a hi-tech solution for accurately reproducing the full sound of acoustic guitars and other instruments with studio-quality sound live on stage and in the studio. This device allows you to get your acoustic guitar to sound like it does in the studio so you get the best for your stage performance.
With iRig Acoustic Stage, you no longer have to sacrifice great acoustic tone when playing live. iRig Acoustic Stage gives you the best of both worlds, the rich sound of your acoustic guitar as if it were mic’d up in the studio and the freedom to move around without compromising your sound.
iRig Acoustic Stage is a patented, revolutionary digital microphone system that makes your guitar sound exactly as if it was captured with a classic recording studio setup, giving you full rich studio-quality sound on the stage.
It’s a compact acoustic microphone and advanced digital preamplifier and processing unit that recreates a studio microphone set-up providing you with all of the true character and tonal nuance of your acoustic in live playing situations. Simply clip the iRig Acoustic Stage’s microphone to the sound hole, attach it to the iRig Acoustic Stage pre-amplifier processor, then connect the preamp to your amplifier or mixer. iRig Acoustic Stage also features a “Cancel Feedback” button that gets rids of annoying frequency feedback during performance.
*Pictured guitar is not included.
IK iRig Acoustic Stage Features
- Advanced MEMS microphone clips on to sound hole
- Preamp/DSP unit
- Dramatically improves your live acoustic sound
- 1/4" AUX input with volume for piezo, magnetic pickups or other onboard electronics
- 1/4" Output with level control for amplifier or PA system
- USB audio out for recording on a computer or mobile device
- Cancel Feedback with multiple frequency feedback cancelling
- 6 tone presets
- Personal instrument calibration
- Works on any acoustic, acoustic electric or ukulele with round sound hole
- Phase switch for optimising dual source sound
- iRig Acoustic Stage DSP/interface
- Dedicated iRig Acoustic microphone
- Belt clip
- Carrying case
- 2 x 1.5V AA Battery
- Guitar not included in package
- Microphone Type: MEMS
- Polar Pattern: omnidirectional
- Frequency Response: 30 Hz - 20 kHz, +/-3dB
- Max SPL: 130dB SPL
- Signal-to-Noise Ratio: 101 dBA
- Maximum soundboard thickness: 4mm / 0.16"
- Dedicated iRig Acoustic Microphone Input: 2.5mm / 3/32" TS mono jack
- AUX Instrument Input Connector: 6.3mm / 1/4" TS mono jack
- AUX Instrument Input Impedance: 11 kOhms (active instruments only)
- Analog Output Connector: 6.3mm / 1/4" TS mono jack, line-level, low impedance
- Analog Output Impedance: 50 Ohms (can drive long cables without any loss)
- Digital Output Connector: micro-USB
- AD and DA Resolution: 32-bit
- Sampling Rate: 48 kHz
- Interface Output: USB class compliant audio output via micro-USB port
- Power: battery power (2xAA), USB bus power
- Battery Life: approximatively 12 hours of continuous usage with alkaline batteries and 15 hours with rechargeable high quality Ni-MH AA cells (2000 mAh and up)
- DSP/Interface size: 101mm/3.98" x 72.3mm/2.85" x 23mm/0.91" (belt clip excluded)
- DSP/Interface weight: 99g/3.49oz (batteries excluded)
- Microphone size: 31.7mm/1.25" x 32.2mm/1.27" x 18.8mm/0.74"
- Microphone weight: 20g/0.71oz
- Microphone cable length: 150cm/59.1"
- Additional Information
Manufacturer IK Multimedia SKU SIKMIRIGACOUSTICSTAGE Model IP-IRIG-ACOSTG-IN GTIN 08025813700031 Single or Pair N/A