T: 0151 707 4545

DPA ST2011A - Stereo Pair, 2x 2011A Microphones

£1,560.00 £1,300.00 (ex. vat)

DPA ST2011A - Stereo Pair, 2x 2011A Microphones

  • DPA ST2011A - Stereo Pair, 2x 2011A Microphones

DPA ST2011A - Stereo Pair, 2x 2011A Microphones

The DPA d:dicate ST2011A Stereo Pair is a twin diaphragm cardioid condenser microphone set. Sharing much of the same technology and design ethos from the 4000 series, DPA’s flagship mic line, the 2011A offers similar performance for an affordable price.  

The capsule design features two opposite facing diaphragms, which are rebuilt into a single capsule composition. This means the mic has the advantages of a small capsule, with a fast impulse response and a large frequency bandwidth, but has lower inherent noise thanks to its larger overall diaphragm surface area. The 2011 offers linear response at off axis positions, meaning a better gain to feedback ratio and making stage separation and mic level easier to control.

The ST2011A is a complete DPA 2011A stereo pairing with two handpicked cardioid microphones, selected on sensitivity within ±1.5 dB making several stereo principles like XY and ORTF easy to obtain.

Each mic is also of a modular design, meaning it’s easy to swap out the capsule to change the pick-up pattern with any other DPA capsule head or preamp body. 

DPA ST2011 A Stereo Pair Features

  • Sensitivity selected pair
  • Superb stage separation and level control
  • All-round workhorses
  • PeliTM Case transportation and protection

DPA ST2011A Specifications

Directional pattern: Cardioid
Principle of operation: Pressure gradient, with interference tube
Cartridge type: Pre-polarized condenser, Twin Diaphragm Capsule
Frequency range: 20 Hz - 20 kHz
Frequency range, ± 2 dB, at 30 cm: 50 Hz - 17 kHz with 3 dB soft boost at 12 kHz
Sensitivity, nominal, ± 2 dB at 1 kHz: 10 mV/Pa; -40 dB re. 1 V/Pa
Equivalent noise level, A-weighted: Typ. 20 dB(A) re. 20 µPa (max. 23 dB(A))
Equivalent noise level, ITU-R BS.468-4: Typ. 33 dB (max. 36 dB)
S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL): Typ. 74 dB(A)
Total Harmonic Distortion (THD) at 1 kHz: < 1 % up to 137 dB SPL peak
Dynamic range: Typ. 117 dB
Max. SPL, peak before clipping: 153 dB
Switchable attenuator: 0 dB / -20 dB
Output impedance: < 200 ohm
Minimum load impedance: 2 kohm
Cable drive capability: 100 m (328 ft)
Output balance principle: Impedance balancing with Active Drive
Common Mode Rejection Ratio (CMRR): > 60 dB
Power supply (for full specifications): 48 V Phantom power (± 4 V)
Current consumption: 2.8 mA
Connector: XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
Color: Matte black
Weight: 164 g (5.8 oz)
Microphone diameter: 19 mm (0.75 in)
Microphone length: 198 mm (7.8 in)
Output voltage, RMS: > 5 V
Polarity: +V at pin 2 for positive sound pressure
Temperature range: -40 °C to 45 °C (-40 °F to 113 °F)
Relative Humidity (RH): Up to 90%
Sensitivity selection tolerance (at 1 kHz): ± 1.5 dB
Manufacturer DPA Microphones
Model DPA ST2011A - Stereo Pair, 2x 2011A Microphones
DPA Microphones
DPA Microphones
DPA ST2011A - Stereo Pair, 2x 2011A Microphones
Contact Us

Studiocare Professional Audio Ltd.

Unit 2, 56 Evans Road


L24 9PB

+44 (0) 151 707 4545
+44 (0) 845 345 8910

Opening Hours
Mon - Fri: 9:30 - 5:30
Sat - Sun: Closed

How To Find Us
Terms & Conditions
Returns Form
Repair Request
Studiocare on FacebookStudiocare on TwitterStudiocare on Google+” width=Studiocare on YoutubeStudiocare on Pintrest

© Copyright Studiocare Professional Audio Ltd. 2016