Skip to content
Free UK Mainland Delivery for Orders Over £99 - Need some advice? Talk to the team on 0151-236-7800
Free UK Mainland Delivery for Orders Over £99

DPA d:dicate™ 4011A Cardioid Mic

£1,578.00 inc. vat
£1,315.00 ex. vat
SKU SDPA4011
In Stock - Available for Immediate Dispatch

DPA d:dicate™ 4011A Cardioid Mic

The DPA d:dicate 4011A is a cardioid condenser mic that performs with accuracy, neutral sound and very low distortion.

The 4011A’s cardioid pick up pattern provides high signal separation when the mic is used on instruments and sound sources, and performs well when close mic’ed on guitar, piano, overheads, percussion, wind instruments and vocals. For use on drums or other high SPL instruments like trumpet and saxophone, the mic can handle 159dB and also includes a -20dB pad for extra overload protection. The 4011A has a linear and flat frequency response both on and off axis at up to 90 degrees from the source, and the off axis response ensures any spill from other instruments is uncoloured.  

The mic is built around a modular design, meaning the body and the capsule can be swapped out for a different polar pattern or body preamp. 

DPA 4011A Features

  • Close-miking
  • Superior for high sound levels
  • Accuracy
  • Colorless

DPA 4011A Specifications

  • Directional characteristics: Cardioid
  • Principle of operation: Pressure gradient
  • Cartridge type: Pre-polarized condenser
  • Frequency range: 20 Hz to 20 kHz
  • Frequency range, ±2 dB: 40 Hz to 20 kHz
  • Sensitivity, nominal ±2 dB at 1 kHz: 10 mV/Pa; -40 dB re. 1 V/Pa
  • Equivalent noise level, A-weighted, re. 20 µPa: Typ. 18 dB(A) re. 20 µPa (max. 20 dB)
  • Equivalent noise level, ITU-R BS.468-4: Typ. 25 dB (correct with the attenuator in 0 dB or -20 dB setting)
  • S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL): Typ. 76 dB(A)
  • Total Harmonic Distortion (THD): < 1 % up to 139 dB SPL peak
  • Minimum load impedance: 2 kohm
  • Dynamic range: Typ. 121 dB
  • Max. SPL, peak before clipping: 159 dB
  • Switchable attenuator: 0 dB / -20 dB
  • Output impedance: < 200 ohm
  • Cable drive capability: 100 m (328 ft)
  • Output balance principle: Impedance balancing with Active Drive
  • Common Mode Rejection Ratio (CMRR): > 60 dB
  • Power supply (for full specifications): 48 V Phantom power (± 4 V)
  • Current consumption: 2.8 mA
  • Connector: XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
  • Color: Matte black
  • Weight: 158 g (5.6 oz)
  • Microphone diameter: 19 mm (0.75 in)
  • Capsule diameter: 19 mm (0.75 in)
  • Length: 170 mm (6.7 in)
  • Output voltage, RMS: > 5 V
  • Polarity: +V at Pin 2 for positive sound pressure
  • Temperature range: -40 °C to 45 °C (14 °F to 113 °F)
  • Relative Humidity (RH): Up to 90 %
  • Matching tolerance: ± 1 dB
  • Phase deviation for kit: < 10°