T: 0151 707 4545

Audio Technica ATW-2410A/P - 2000a series racked system with 4 tie-clip microphones

£1,457.40 £1,214.50 (ex. vat)

Audio Technica ATW-2410A/P

  • Audio Technica ATW-2410A/P
  • Audio Technica ATW-T210a
  • Audio Technica ATW-R2100a
  • Audio Technica AT829cW
  • Audio Technica ATW-DA49
  • Audio Technica ATW-DA49 Rear

Audio Technica ATW-2410A/P - 2000a Series Racked System with 4 Tie-Clip Microphones

The Audio Technica ATW-2410A/P is a complete wireless system featuring 4 x ATW-T210a body-pack transmitters, 4 x AT829cW tie-clip microphones, 4 x ATW-R2100a receivers, ATW-DA49 distributor, rack box and transmitter shoulder bag.

4 channels of 2000a series wireless systems and professional antenna distribution system all pre racked into a high quality flight case. All system settings are preprogramed into the units so all you need to do is plug in and turn on. All systems come with a padded shoulder bag for safely storing the microphone and belt pack transmitters. Only available in the UK.

2000 Series Specifications

  • Operating Frequencies: UHF band
    • 606.500 – 629.900 MHz (U Band – ch.38)
    • 856.100 – 864.900 MHz (F Band)
  • Number Of Channels: 10 total
  • Frequency Stability: ±0.005%, Phase Lock Loop frequency control
  • Modulation Mode: FM
  • Operating Range: 100 m (300') typical
  • Operating Temperature Range: 41° F (5° C) to 113° F (45° C)
  • Frequency Response: 100 Hz to 15,000 Hz

ATW-R2100a Receiver Specifications

  • Receiving System: True diversity
  • Image Rejection: 55 dB nominal, 50 dB minimum
  • Signal-To-Noise Ratio: >100 dB at 40kHz deviation (A-weighted), maximum modulation 40 kHz
  • Total Harmonic Distortion: < 1% (at 1 kHz, ±20 kHz deviation)
  • Sensitivity: 20dBuV (S/N 60dB at 5 kHz deviation, IEC-weighted)
  • Audio Output:
    • Unbalanced: 25mV (100k ohms load), 1/4" phone jack
    • Balanced: 50mV (Attenuator; 0dB)
    • 12.5mV (Attenuator; -12dB) at 1 kHz ± 5kHz
    • deviation, 100k ohm load, XLRM-type
  • Antenna Input: BNC-type 50 Ohms – Bias voltage 12V DC, 60mA each
  • Dimensions: 210 mm x 44 mm x 162.2 mm (W x H x D)
  • Weight: 1.0kg (2.2 lbs)
  • Accessories Furnished: Two flexible UHF antennas, rack mount adapters, AC adapters
  • Optional System Accessory: AT8630 joining-plate kit, mounts two ATW-R2100a receivers in single 19" rack space

ATW-T210A UniPak Boy-Pack Transmitter

2000a Series UniPak™ transmitter. Tone Lock™ tone squelch system fights interference. Compatible with the Wireless Essentials Range. Quick slide Power button is great for easy access with 10 selectable channels available to choice from.

  • Rf Power: Output High: 30mW; Low: 10mW, nominal
  • Spurious Emissions: According to National Regulations
  • Batteries: Two 1.5V AA alkaline or rechargeable AA NiMH (not included)
  • Current Consumption: 150 mA typical
  • Battery Life: Approximately 9 hours (low), 7 hours (high)
  • Dimensions: 66 mm x 92.3 mm x 22.5 mm (W x H x D)
  • Weight (Without Battery): 80 grams

AT829cW Cardioid Condenser Lavalier 

The AT829cW is a cardioid condenser lavalier microphone terminated with locking 4-pin connector for A-T UniPak® body-pack wireless transmitters. 55" (1.4 m) cable.

ATW-DA49 Distributor

The ATW-DA49 is a UHF (wide-band 440-900 MHz) active unity-gain diversity antenna distribution system that enables one pair of antennas to feed multiple wireless systems. Provides two “1-in, 4-out” RF channels; connects a pair of antennas to as many as four wireless receivers. Either passive or active antennas may be used. Both input jacks offer switchable +12V DC output on their center pins to operate Audio-Technica powered antennas or other in-line RF devices if desired. The unit features all-metal construction for extreme durability and protection from radio frequency interference.

The ATW-DA49 is designed to complement Audio-Technica 2000 and 3000 Series wireless systems. It is also suitable for many other wireless systems operating within the 440-900 MHz range.

Includes ten RF cables, front-mount antenna cables and connectors, four DC power cables, +12V DC desktop power supply with detachable IEC power cable, and ATW-RM1 rack-mount hardware kit to permit attachment in a standard 19” rack space.

View on the Audio Technica Europe Website.

Manufacturer Audio Technica
Model ATW-2410A/P
Audio Technica
Audio Technica
Contact Us

Studiocare Professional Audio Ltd.

Unit 2, 56 Evans Road


L24 9PB

+44 (0) 151 707 4545
+44 (0) 845 345 8910

Opening Hours
Mon - Fri: 9:30 - 5:30
Sat - Sun: Closed

How To Find Us
Terms & Conditions
Returns Form
Repair Request
Studiocare on FacebookStudiocare on TwitterStudiocare on Google+” width=Studiocare on YoutubeStudiocare on Pintrest

© Copyright Studiocare Professional Audio Ltd. 2016